Surfboard repair question
Surfing yesterday I "blew out" a fin plug. It actually looks like it was crushed into the board about 1/4"- 3/8". The fin now sits at a slightly goofy angle and after my session there was water bubbling out of the fun plug. The glass around it is not spider cracked or anything but the white filler around the plug appears to be what failed. Do I need to totally pull that bad-boy out and redo it or is there an easier / better solution? This is a nice board and I want to make sure I do it right...
This is a standard glassed foam board, no epoxy or firewire or anything like that.
Thanks in advance!