Dropping a link like that is a bit spamish...and I didn't listen to the entire recording...however a few questions about the 3d printing: How long it take you to print out your fin? Also, what was the material cost to print it?
I'm confused I don't under stand any of this
Roy, great words keep it up. Always interesting to hear a builders perspective with cool interviews like this. I dig the non main stream surfing corporation approach.
I'll let the moderator who removed this know, that this is not too spammy, because its surf related and relevant. Carry on.
Roy the interview was interesting. A beach bum lol. Is great barrier island east or west coast NZD ?
Cool interview, I`m sold. How much to buy/ship one of your boards to Maine for?
The admins wont be identified, so they dont have to endure harassment for enforcing the rules.
There were a lot of people interested, and I picked a few, who have had good history on this board IMO and have had a willingness to help create a good environment. I will oversee their actions in case I think they are being biased or unfair.
Now, back on topic...