LOGIN | REGISTER

Page 4 of 4 FirstFirst ... 234
Results 31 to 35 of 35

Thread: What to do?

  1. #31
    Join Date
    Aug 2009
    Location
    Monmouth Beach, NJ
    Posts
    2,578
    Quote Originally Posted by zaGaffer View Post
    ...the part that you cut away, that was fiberglass and resin. What you put back on, that was just resin. So the problem is, that's got no strength anymore...

    2nd problem...if you put a polyester resin on an EPS (epoxy) foam board, as I understand it, it can damage the EPS foam.
    Yes... and yes. If any poly resin got down under that layer of epoxy and glass, the styrene in the resin will literally dissolve the polystyrene (EPS) foam... if it is, indeed, polystyrene foam. There's always the possibility of epoxy being used over polyurethane foam, which of course is fine.

    After looking at the pictures, there's a lot of issues with this board, including water damage along the stringer. Looks like mold growing in the foam, which is pretty common with old, waterlogged boards. I wouldn't invest much into repairing it, except for sanding down that resin you added, and putting a layer or two of cloth over the area. Then sand that down, and paint some resin over that. Sand it smooth and ride it.
    Last edited by LBCrew; Mar 22, 2013 at 01:51 PM.

  2. #32
    Join Date
    Aug 2012
    Location
    South Shore, MA
    Posts
    188
    Thanks zaGaffer/LBCrew! Words of wisdom. There's an extra layer of fiberglass that didn't delaminate so I think I'm safe with the foam not dissolving. Also, not too worried strength b/c it's the bottom of the board and it's already got a layer of fiberglass. At this point, I think I'm just gonna plow ahead and finish it off with a little more resin. Like you guys said, her days are numbered. I'll follow up and let you know when she finally kicks the bucket...

  3. #33
    Quote Originally Posted by sonfollowerssurf View Post
    Will be in Massachusetts in July.
    I forgot you were omnipresent, dang.

  4. #34
    Join Date
    Aug 2012
    Location
    South Shore, MA
    Posts
    188
    So I said I would follow up when my board finally kicked the bucket and here we are. A few weeks ago I traded boards with a friend in order to try out her new longboard. She was paddling out on my board, tried turtling under a thigh high wave and it snapped right in half.

    Now I have a chunk of foam covered in fiberglass that’s 6’2” long, 22.25” wide and 2.75” thick. I started peeling back the fiberglass last night and it’s quite the process, but I’m finding that a paint scraper and wire snips can do the trick.

    Any suggestions on what kind of shape I can make out of this? I would think a mini simmons would be the most obvious, but I’m really feeling a single fin egg shape. What do you guys think?

  5. #35
    Join Date
    Aug 2012
    Location
    South Shore, MA
    Posts
    188
    IMAG0426.jpgIMAG0424.jpgIMAG0425.jpg

    Forgot to attach pics