After looking at the pictures, there's a lot of issues with this board, including water damage along the stringer. Looks like mold growing in the foam, which is pretty common with old, waterlogged boards. I wouldn't invest much into repairing it, except for sanding down that resin you added, and putting a layer or two of cloth over the area. Then sand that down, and paint some resin over that. Sand it smooth and ride it.
Results 31 to 35 of 35
Thread: What to do?
Mar 22, 2013, 12:49 PM #31
Last edited by LBCrew; Mar 22, 2013 at 12:51 PM.
Mar 22, 2013, 04:18 PM #32
Thanks zaGaffer/LBCrew! Words of wisdom. There's an extra layer of fiberglass that didn't delaminate so I think I'm safe with the foam not dissolving. Also, not too worried strength b/c it's the bottom of the board and it's already got a layer of fiberglass. At this point, I think I'm just gonna plow ahead and finish it off with a little more resin. Like you guys said, her days are numbered. I'll follow up and let you know when she finally kicks the bucket...
Jul 23, 2013, 03:09 PM #34
So I said I would follow up when my board finally kicked the bucket and here we are. A few weeks ago I traded boards with a friend in order to try out her new longboard. She was paddling out on my board, tried turtling under a thigh high wave and it snapped right in half.
Now I have a chunk of foam covered in fiberglass that’s 6’2” long, 22.25” wide and 2.75” thick. I started peeling back the fiberglass last night and it’s quite the process, but I’m finding that a paint scraper and wire snips can do the trick.
Any suggestions on what kind of shape I can make out of this? I would think a mini simmons would be the most obvious, but I’m really feeling a single fin egg shape. What do you guys think?
Jul 23, 2013, 03:11 PM #35