Any advice on fixing a delam on a Sunova board. It's a balsa skinned, vacuum bagged, epoxy core with a large delam on the deck from the previous owner leaving it in his car. If it were fiberglass, I'd just cut out the delamed patch, put some resin underneath then slap the cloth back on top with some new bits around the cut. Same thing here maybe?
Little out of my comfort zone, I don't even own a vacuum pump and stick to shaping/glassing poly. Haven't bought it yet, but the price is right and I like Bert's boards, just don't know about fixing this one.
Any advice is appreciated. Thanks.
Results 1 to 4 of 4
Thread: Sunova Delam
Jul 3, 2013, 06:23 PM #1
Jul 3, 2013, 07:01 PM #2
Jul 3, 2013, 09:49 PM #3
It sounds like you may have to go for the drill, fill, press sequence. I doubt you need a vac bag, just something that can apply decent pressure evenly.
Jul 3, 2013, 10:04 PM #4