LOGIN | REGISTER

Page 2 of 2 FirstFirst 12
Results 11 to 11 of 11
  1. #11
    so after a few hours of sanding and digging out all the putty and mushy discolored foam this is what I have. Because there was so much damaged foam im gonna have to fill it with q cell before I redrill the holes for the plugs. Im not completely sure of how long after i put in the q cell I should drill the holes in terms of not messing with the strength of it but not letting it get too hard so it makes it harder. Are there any foolproof guidelines for this?
    Also upon removing all of this I realized that the shaper didnt use the H pattern design for FCS plugs. Should I attempt to make this or continue on the trend of the rest of the board?
    Attached Images Attached Images
    Last edited by paddle out; Apr 19, 2009 at 01:57 AM.