Separate names with a comma.
1. Shelter - All the best pro's staying in one house surfing together 2. Step Into Liquid - Pure stoke and Cortez 3. Drive Thru - any of them 4....
I'm ok with them charging reasonable beach access fees to cover lifeguards, clean-up, etc. That shouldn't fall on just the homeowners. However,...
Classic Are you going to clean all the gas and oil out of an aircraft carrier??? Seems like a rock jetty would be a better idea. Or how about...
Bullsh!t... I own a 3/2 flash bomb and the only thing that is completely dry in 1.5hrs is the flash dry liner. The neoprene inside and out takes...
The stupid Go-Pro cameras on their boards are so distracting. Once again sponsorship dollars ruining surfing...
Don't be lazy. Learn your breaks and use the buoys.
So I actually own a Flash Bomb (3/2) unlike the other replies (except maybe Gnar?)... and I will reply to your specific questions rather than...
If you have a steady hand you can do a Loxbox quad install without the jig. Doesnt really work for a thruster center fin due to the stringer....
Get Lokbox fins for your next quad. They allow for 1/2" of adjustment fore and aft. If your quad fins are placed properly you don't need the...
We don't call it "Rocktober" for groveling a knee to waist high wave. I think the OP has grounds to complain. Although it is only 10/3....
Ok.... OBHOLCRAR.... Damn I've always been a bad speller.
It's actually quite easy to figure out where that cam is if you surf around Monmouth county with any kind of frequency. However, knowing exactly...
Good tip on sanding the laps, BUT there actually is a reason to sand your lam. If you are outside of the recoat window for your resin you will...
Survey says... X ...wrong answer.
That sure would be tough to finger out considering the cam is actually not in Monmouth Beach. In fact if you were looking for the Monmouth Beach...
I have a CJ Arrow. It's an awesome noserider. Great board when the waves are small and peeling. Locks in on the wave and trims from the center...
So I'm assuming you placed them so far up the board because your intent is to prevent deck denting from your hands? Was that your intent?...
Just curious, can you explain why you chose that placement for the carbon patches?
No, I'm from NJ not CA, can't you read?
I rode those penny boards before they were "retro". While they are a blast to ride they've got nothing on the Carver C7 truck when it comes to...
