Its a normal foam kick pad, and an epoxy board with EPS foam. I remember reading here that superglue will melt EPS, but what if its not exposed? Anyone know anything strong enough to hold a piece of this pad back on without melting my board? Its a green room board, and glass if that makes a difference.
I've used Plumber's Goop to re-attach the edges of pads that start to peel off, but I wouldn't use it on the whole pad. It's too expensive. But blows Super Glue away.
I ended up going with the 3M 80. Worked like a charm. It was still a little tacky after 12 hours of setting, and held like a champ in yesterdays swell. Thanks again.
