If I am glassing a board and want to draw an image with some writing. What is the best material to use to write on? Also what should I use to draw/write with so that the resin does not mess it up while glassing?
Is there a special method or any other things I should know while doing this?
Thanks for the help.
Results 1 to 3 of 3
Thread: Glassing a Board
May 13, 2012, 04:33 AM #1Junior Member
- Join Date
- May 2012
Glassing a Board
May 13, 2012, 05:30 AM #2
disclaimer.....dont do it you lack the experience.... its going to look sloppy your going to be disappointed regardless of your art ability.
that being said do any art work before the hot coat . air brush is the best option or rice paper some clip art . picasso pens work to,
www.swaylocks.com best board building site
dont do it
May 13, 2012, 12:22 PM #3
- Join Date
- Jan 2009
- milton delaware
Also you could just glass and hotcoat the board, then draw on the outside of the sanded hoatcoat and protect the art with some clear coat. If you arent sure of your ability, this is the safest way to do it. Dont like it? Sand it off.
Last edited by mitchell; May 13, 2012 at 12:24 PM.